UL PRODUCT CATEGORY

Foamed Plastic


See General Information for Foamed Plastic

DYPLAST PRODUCTS L L CR12579
12501 NW 38TH AVE
MIAMI, FL 33054 USA

Foamed plastic in the form of boards.

SURFACE BURNING CHARACTERISTICS

6 In. Max +
Flame spread 5#
Smoke developed 300

+Installed in a thickness or stored in an effective thickness, as indicated, for a density of 1.00 to 2.00 lb per cu ft.

#Flame spread and smoke developed recorded while material remained in the original test position. Ignition of molten residue on the furnace floor resulted in flame travel equivalent to calculated flame spread index of 110 and smoke developed index of over 500.

5 In. Max *
Flame spread 5#
Smoke developed 160-200#

*Installed in a thickness, or stored in an effective thickness, as indicated, for a density of 1.00 to 2.00 lb per cu ft.

#Flame spread and smoke developed recorded while material remained in the original test position. Ignition of molten residue on the furnace floor resulted in flame travel equivalent to calculated flame spread classification of 135 and smoke developed classification of Over 500.

6 In. Max +
Flame Spread 20#
Smoke Developed 185#

+Installed in a thickness or stored in an effective thickness, as indicated, for a density of 1.00 to 1.25 lb per cu ft.

#Flame spread and smoke developed recorded while material remained in the original test position. Ignition of molten residue on the furnace floor resulted in flame travel equivalent to calculated flame spread classification of 40 and smoke developed classification of over 500.

Last Updated on 2019-08-07
BRYX.R12579 R12579 BRYX 123105001 LISTING Active 20190807 20190807

The appearance of a company's name or product in this database does not in itself assure that products so identified have been manufactured under UL's Follow-Up Service. Only those products bearing the UL Mark should be considered to be Certified and covered under UL's Follow-Up Service. Always look for the Mark on the product.

UL permits the reproduction of the material contained in the Online Certification Directory subject to the following conditions: 1. The Guide Information, Assemblies, Constructions, Designs, Systems, and/or Certifications (files) must be presented in their entirety and in a non-misleading manner, without any manipulation of the data (or drawings). 2. The statement "Reprinted from the Online Certifications Directory with permission from UL" must appear adjacent to the extracted material. In addition, the reprinted material must include a copyright notice in the following format: "© 2019 UL LLC".